Rod End cap

Rod End cap

Our Stainless Steel Cable & Rod supports are perfect for all your indoor applications. The elegant finishes that we carry will give your display a unique look that will make it stand out like no other! Thanks to the easy installation process you can have an exhibit displayed anywhere you would like in no time! If you look below you will notice technical descriptions about this particular support.
SKU: ARA1630
Qty: 0-99 100-499 500+ 1000+
$1.53 $1.36 Contact Us
Save: 0% 10% 20% %
Sku ARA1630
Diameter 5/8''
Distance From Wall 3/16''
Material Aluminum
Finish Clear Anodized
Inside/Outside Outside Or Inside Use
Thickness Material Accepted Between (1/8'' and 3/8'')
Length 7/8''
Minimum Thick. Material 1/8''
Maximum Thick. Material 3/8''
Installation Hardware None Needed
Tools Required M5 Hex key, M6 Hex key

The installation process is very easy!
First, mark where you will be hanging your wall, ceiling, or floor mounts.
Then, drill any necessary holes and install your anchors.

The rod will be installed into both the Tensioner and the Ceiling mount and then tightened down.

Before installing anything, slide your Rod Supports onto your rod, then install the bottom components, followed by your rod and your upper components.

If you are installing a Wall Mounted System, you will install the Vertical Assembly Arm(s) and then attach the Rod Tensioner and/or Ceiling Mount into the Vertical Assembly arm.
All that's left is to hang your material, tighten the set screws, and enjoy your beautiful display!